Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: Head-up display does not illuminate. | ||||
1 | Were you sent here from the IPC Diagnostic System Check? | -- | ||
2 |
Does the IPC perform a complete sweep test (minimum to maximum) on all gauges? | -- | ||
3 |
Do all segments of the head-up display illuminate for 3.5 seconds? | -- | System OK | |
4 | Inspect for poor connections at the harness connector of the head-up display switch and IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs Did you find and correct the condition? | -- | ||
5 | Inspect for poor connections at the harness connector of the head-up display . Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs Did you find and correct the condition? | -- | ||
6 | Test the head-up display switch circuit for a short to ground, short to voltage, or an open. Refer to Circuit Testing and Wiring Repairs Did you find and correct the condition? | -- | ||
7 | Replace the head-up display switch. Refer to Head Up Display Switch Replacement . Did you find and correct the condition? | -- | ||
8 | Replace the head-up display . Refer to Instrument Cluster Head Up Display Replacement . Did you find and correct the condition? | -- | ||
9 | Replace the IPC assembly. Refer to Instrument Cluster Replacement . Did you complete the replacement? | -- | -- | |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | |
