Circuit Description
When a receiver is replaced, program all transmitters to the new electronic door lock receiver. DTC B2805 will remain current until at least one transmitter is programmed. The electronic door lock receiver can stored up to 3 identification codes at a time.
Conditions for Setting the DTC
The electronic door lock receiver has indicated that no transmitter Vehicle Access Code (VAC) has been programmed.
Action Taken When the DTC Sets
| • | Stores a DTC B2805 in the receiver memory |
| • | No driver warning message will be displayed for this DTC. |
Conditions for Clearing the DTC
The electronic door lock receiver can only detect this condition as a current code. Therefore, when the receiver has indicated that a valid VAC was programmed properly, this DTC will automatically clear.
Diagnostic Aids
A DTC B2805 will remain stored in the receiver's memory until at least one transmitter is programmed.
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
Tests if the remote control door lock receiver was recently replaced. Program the keyless entry transmitters and the tire pressure monitor sensors when the remote control door lock receiver is replaced. Refer to Transmitter Programming/Synchronization and Tire Pressure Monitoring Sensor Programming in Tire Pressure Monitor.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Were you sent here from the Remote Keyless Entry Diagnostic System Check? | -- | ||
Was the remote control door lock receiver recently replaced? | -- | |||
3 | Program the transmitters. Refer to Transmitter Programming/Synchronization . Did you complete the programming procedure? | -- | -- | |
4 |
Did you complete the replacement? | -- | -- | |
5 |
Does the DTC reset? | -- | System OK |
