GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Corvette 🢒 HVAC 🢒 HVAC Systems - Manual 🢒 Defroster Valve Actuator Replacement

Removal Procedure

    Object Number: 295305 Size: SH
  1. Remove the IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gauges and Console.
  2. Disconnect the RH side window defogger lower outlet duct from the windshield defroster duct, then reposition the side window defogger duct forward.
  3. Disconnect the vacuum harness connectors from the defroster actuator.
  4. Rotate the defrost door lever fully rearward (counterclockwise), then carefully insert a flat bladed tool between the bottom of the defrost door lever and the protruding wall of the HVAC module case below the door lever in order to keep the door lever in place.

    5. Object Number: 295306 Size: SH
  5. Lift to release the defroster actuator retaining tab and begin to slide the actuator toward the passenger SIR bracket.
  6. Carefully rotate the defroster actuator upward and forward until the actuator clears the passenger SIR bracket.

    7. Object Number: 295308 Size: SH
  7. Disconnect the defroster actuator pushrod from the defrost door lever and remove the actuator.

Installation Procedure

    Object Number: 295308 Size: SH
  1. Connect the defroster actuator pushrod to the defrost door lever.

    2. Object Number: 295306 Size: SH
  2. Position the defroster actuator along side of the passenger SIR bracket in line with the mounting pins on the HVAC module case.
  3. Carefully rotate the defroster actuator past the passenger SIR bracket, rearward and downward, until the actuator slots align with the HVAC module mounting pins.
  4. Inspect that the defroster actuator pushrod is not binding on the defrost door lever.
  5. Push the defroster actuator toward the HVAC module case to secure the retaining tab.

    6. Object Number: 295305 Size: SH
  6. Remove the flat bladed tool maintaining the defrost door lever in position.
  7. Connect both of the vacuum harness connectors to the defroster actuator.
  8. Position and connect the RH side window defogger lower outlet duct to the windshield defroster duct.
  9. Install the IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement in Instrument Panel, Gauges and Console.