Removal Procedure
- Remove the front floor kick-up panel. Refer to Front Floor Kick-Up Panel Replacement in Interior Trim.
- Remove the Bose Module. Refer to Bose Module Replacement in Entertainment.
- Disconnect the air temperature actuator electrical connector.
- Remove the air temperature actuator retaining screws.
- Remove the air temperature actuator.
Installation Procedure
- Position the air temperature actuator, then align the slots in the temperature actuator driver to the flats on the temperature door shaft.
- Slide the air temperature actuator driver onto the shaft, while aligning the actuator locating hole to the forward alignment pin on the HVAC module case.
- Install the air temperature actuator retaining screws.
- Connect the air temperature actuator electrical connector.
- Install the Bose Module. Refer to Bose Module Replacement in Entertainment.
- Install the cover to the IP electrical center.
- Install the front floor kick-up panel. Refer to Front Floor Kick-Up Panel Replacement in Interior Trim.
Important: The air temperature actuator driver should completely seat onto the temperature door shaft and the actuator mounting holes should be flush with the mounting bosses on the HVAC module case.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
