GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Corvette 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Windshield Wiper System Module Replacement

Removal Procedure

    Object Number: 70096 Size: SH
  1. Remove the wiper motor fuse. The wiper motor fuse is located in the instrument panel electrical center.
  2. Move the wiper arms until the wiper arms are in the mid-wipe position.
  3. Remove the wiper arm and blade assemblies. Refer to Windshield Wiper Arm Replacement .
  4. Remove the air inlet screen. Refer to Air Inlet Grille Panel Replacement in Body Front End.

    5. Object Number: 70091 Size: SH
  5. Remove the wiper motor module mounting bolts.
  6. Disconnect the wiper motor electrical connector.

    7. Object Number: 70104 Size: SH
  7. Remove the wiper motor module from the vehicle.

Installation Procedure

    Object Number: 70104 Size: SH
  1. If the wiper motor module is a replacement (new) module, move the wiper linkage until the wiper linkage is in the mid-wipe position.
  2. Place the wiper motor module into the vehicle.
  3. Connect the wiper motor module electrical connector.

    4. Object Number: 70091 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the wiper motor module mounting bolts.

    5. Tighten
    Tighten the wiper motor module mounting bolts to 10 N·m (89 ft in).


    Object Number: 70096 Size: SH
  5. Install the air inlet screen onto the vehicle. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Install the wiper motor fuse.
  7. Turn the ignition switch to the RUN position, place the wiper switch in the lowest INT (delay) position. When the motor reaches the inner-wipe position, turn the ignition switch OFF.
  8. Install the wiper arm and blade assemblies on to the vehicle. Refer to Windshield Wiper Arm Replacement .