Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Instrument Cluster Schematics | ||||
1 | Did you perform the IPC Diagnostic System Check? | -- | Go to Step 2 | |
2 | Verify the high oil temperature indicator in the message center is always on. Does the system operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Is the Oil Temp below the specified value? | 160°C (320°F) | Go to Step 6 | Go to Step 4 |
4 |
Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 5 |
5 | Test the engine oil temperature sensor ground circuit for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 7 |
6 | Replace the IPC. Refer to Instrument Cluster Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the oil temperature sensor. Refer to Engine Oil Temperature Gage Sensor Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
