For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle Lifting and Jacking the Vehicle in General Information.
- Remove the front bumper fascia lower close out panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement .
- Remove the front brake caliper cooling duct. Refer to Front Brake Caliper Cooling Duct Replacement
- Remove the wiring harness' plastic clips (1).
- Remove the two clips at the top of the fascia grille (2).
- Remove the two fascia grille screws .
- Remove the fascia grille through the front of the opening.
Installation Procedure
- Install the fascia grille through the front of the opening.
- Install the two fascia grille screws.
- Install the two clips at the top of the fascia grille (2).
- Install the wiring harness' plastic clips (1).
- Install the front brake caliper cooling duct. Refer to Front Brake Caliper Cooling Duct Replacement
- Install the front bumper fascia lower close out panel. Refer to Front Bumper Fascia Lower Close Out Panel Replacement .
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fascia grille screws to 1.9 N·m (17 lb in).
