For 1990-2009 cars only
Removal Procedure
- Install the pin into the park brake pedal. Refer to Parking Brake Cable Adjuster Disabling .
- Remove the release handle. Refer to Parking Brake Release Handle Assembly Replacement .
- Remove the left side kick panel. Refer to Body Hinge Pillar Trim Panel Replacement .
- Remove the front brake cable from the pedal.
- Remove the pedal retaining nuts.
- Remove the pedal from the vehicle.
Installation Procedure
- Install the pin into the NEW pedal. Refer to Parking Brake Cable Adjuster Disabling .
- Install the pedal to the vehicle.
- Install the pedal retaining nuts.
- Connect the front brake cable to the pedal.
- Install the release handle. Refer to Parking Brake Release Handle Assembly Replacement .
- Install the left side kick panel by snapping into the pillar. Refer to Body Hinge Pillar Trim Panel Replacement .
- Remove the pin from the park brake pedal. Refer to Parking Brake Cable Adjuster Enabling .
- Move the pedal into the FULL up position.
- Verify that the vehicle will hold position with the brake pedal depressed.
- If additional adjustments need to be made, refer to Park Brake Adjustment .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the pedal retaining nuts to 25 N·m (18 lb ft).
