Tools Required

Caution: Refer to Cracked Window Caution in the Preface section.

Important: Before cutting out a liftgate window , apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. Open the liftgate.
2. Remove the liftgate window trim panel. Refer to Liftgate Trim Panel Replacement .
3. Disconnect the rear defogger wires.

Caution: Refer to Defroster Outlet Caution in the Preface section.

4. Cover the following parts to protect from broken glass:

•	Upper dash pad

•	Defroster outlets and air conditioning (A/C) outlets

•	Seats and carpeting

Caution: Refer to Glass and Sheet Metal Handling Caution in the Preface section.

Important: Keep the cutting edge of the tool against the liftgate window. Do this from inside the vehicle to protect the outer painted surface.

5. Remove the window from the urethane adhesive.

•	Leave a base of urethane approximately 2 mm (0.078 in) on the pinch-weld flange.

•	The only suitable lubrication is clear water.

•	Use the J 24402-A , J 39032 or equivalent in order to remove the liftgate window.




6. With the aid of an assistant, remove the window (1) from the vehicle.

1. Install the liftgate window locator pins to the slots in the opening of the liftgate panel.
2. Connect the rear defogger wires.
3. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
5. Close the liftgate.