Revised Lift Gate Handle Inside Pull Handle Replacement and Liftgate Trim Panel Replacement. Chevrolet HHR 2006

Subject:

SMU - Revised Lift Gate Inside Pull Handle Replacement and Liftgate Trim Panel Replacement

Models:

2006 Chevrolet HHR

This bulletin is being issued to revise the Lift Gate Inside Pull Handle Replacement procedure and the Liftgate Trim Panel Replacement procedure in the Body Rear End sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Lift Gate Inside Pull Handle Replacement

Callout	Component Name
Preliminary Procedure First design only, remove the liftgate trim panel. Refer to Trim Panel Replacement.
1	Liftgate Inside Pull Handle Tip Remove from the back side of the trim panel.

Callout

Component Name

Preliminary Procedure

First design only, remove the liftgate trim panel. Refer to Trim Panel Replacement.

Liftgate Inside Pull Handle

Tip
Remove from the back side of the trim panel.

Trim Panel Replacement - Liftgate

Callout	Component Name
Preliminary Procedure Second design only, remove the liftgate pull handle. Refer to Lift Gate Inside Pull Handle Replacement. DO NOT attempt to remove the liftgate trim panel if there is a failure of the electric latch. Refer to Opening the Liftgate When There Is an Electrical Failure.
1	Liftgate Trim Finish Panel
2	Liftgate Trim Finish Retainer Clips (Qty: 2)
3	Liftgate Lower Trim Finish Panel
4	Liftgate Trim Finish Retainer Clips (Qty: 14)