Step
| Action
| Yes
| No
|
1
|
- Inspect the inoperative bulbs for a damaged or open filament.
- Check that the harness connector seals are not damaged or missing.
Are the bulbs and the harness connectors OK?
| Go to
Step 2
| Go to
Step 7
|
2
|
- Turn the ignition switch to the RUN position.
- Place the turn signal switch to the inoperative side.
- Using a test lamp, backprobe between the inoperative tail/stop/turn
lamp harness connector terminal A to ground.
Does the test lamp flash?
| Go to
Step 4
| Go to
Step 3
|
3
|
| • | LR inoperative: Using a test lamp, backprobe between the C201
terminal A4 to ground. |
| • | RR inoperative: Using a test lamp, backprobe between the C201
terminal A5 to ground. |
Does the test lamp flash?
| Go to
Step 6
| Go to
Step 5
|
4
| Replace the tail/stop/turn lamp. Refer to
Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement
.
Is the repair complete?
| Go to
Exterior Lights System Check
| --
|
5
| Replace the turn signal switch. Refer to
Multifunction Turn Signal Lever Replacement - On Vehicle
in Steering
Wheel and Column - Tilt.
Is the repair complete?
| Go to
Exterior Lights System Check
| --
|
6
|
| • | LR Inoperative: Repair the poor connection or an open in circuit 18
between connector C201 terminal A4 and the left rear tail/stop/turn
lamp. |
| • | RR inoperative: Repair the poor connection or an open in circuit 19
between connector C201 terminal A5 and the rear right tail/stop/turn
lamp. |
Is the repair complete?
| Go to
Exterior Lights System Check
| --
|
7
| Replace the damage component.
Is the repair complete?
| Go to
Exterior Lights System Check
| --
|
