Did you perform the Backup Lights System Check?

--

Go to Step 2

Go to Backup Lamp System Check

1. Turn the ignition switch to the ON position.
2. Place the transaxle in the REVERSE position.
3. Backprobe the right IP junction block C3 connector with a test lamp between the following points:

•	Inoperative LH lamp - the B2 terminal and ground

•	Inoperative RH lamp - the C2 terminal and ground

Does the test lamp light?

--

Go to Step 3

Go to Step 4

1. Disconnect the inoperative rear lamp assembly connector.
2. Connect a test lamp between the following points:

•	Inoperative left lamp - The C terminal of the lamp assembly connector and ground.

•	Inoperative right lamp - The A terminal of the lamp assembly connector and ground.

Does the test lamp light?

--

Go to Step 5

Go to Step 6

Replace the right IP junction block. Refer to Relay/Fuse Center Replacement in Wiring Systems.

Is the repair complete?

--

Go to Backup Lamp System Check

--

Connect a test lamp between the following points:

Does the test lamp light?

--

Go to Step 7

Go to Step 8

Repair the open in CKT 24 between the right IP junction block and the inoperative rear lamp assembly. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Backup Lamp System Check

--

Replace the inoperative rear lamp assembly. Refer to one of the following procedures:

Is the repair complete?

--

Go to Backup Lamp System Check

--

Repair the open in one of the following circuits between the inoperative rear lamp assembly and ground:

Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Backup Lamp System Check

--