GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Malibu 🢒 Body and Accessories 🢒 Seats 🢒 Power Seat Switch Replacement

Removal Procedure

    Object Number: 280436 Size: SH
  1. Remove the seat back recliner handle.
  2. Remove the outer trim panel (5) from the seat cushion.
  3. Disconnect the electrical connector from the power seat switch.
  4. Remove the power seat switch (9).

Installation Procedure

    Object Number: 280436 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the power seat switch (9).

    2. Tighten
    Tighten the screws to 1 N·m (9 lb in).

  2. Connect the electrical connector.
  3. Install the outer trim panel (5) to the seat cushion .
  4. Install the outer trim panel (5) screws.

    5. Tighten
    Tighten the screws to 1 N·m (9 lb in).

  5. Install the seat back recliner handle.
  6. Install the recliner handle screws.

    7. Tighten
    Tighten the screws to 1 N·m (9 lb in).