GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Malibu 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Rocker Panel Molding Replacement

Removal Procedure

    Object Number: 276870 Size: SH
  1. Remove the rocker panel molding screws (2).
  2. In order to remove the rocker panel molding (3) complete the following steps:
    3. 2.1. Push up on the rocker panel molding (3).
    2.2. Disengage the rocker panel molding (3) from the retainers (4).
  3. Remove the rocker panel molding retaining clips (1).

Installation Procedure

    Object Number: 276870 Size: SH
  1. Install the rocker panel molding retaining clips (1).
  2. Snap the rocker panel molding (3) over the retainers (4).

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the rocker panel molding screws (2).

    4. Tighten
    Tighten the screws to 2 N·m (20 lb in).