1. Remove the battery. Refer to Battery Replacement in Engine Electrical.
2. Remove the battery tray.
3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
4. Remove the underhood junction block and position aside. Refer to Underhood Fuse Block Replacement in Engine Electrical.
5. Disconnect the brake pipes (1) from the brake modulator assembly (3).



6. Disconnect the brake pipes (2) from the master cylinder (1).
7. Disconnect the retainers as needed.
8. Remove the brake pipes from the vehicle.

Caution: Always use double-walled steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause brake system failure. Carefully route and retain replacement brake pipes. Always use the correct fasteners and in the original location for replacement brake pipes. Failure to properly route and retain brake pipes may cause damage to the brake pipes and brake system resulting in personal injury.

1. Fabricate a new brake pipe. Refer to ISO Flares Replacement .
2. Install the brake pipes (2) to the vehicle.
3. Loosely install the brake pipe nut to the master cylinder (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Loosely install the brake pipe nut to the brake modulator assembly (3).

Tighten
Tighten the brake pipe nuts to 23 N·m (17 lb ft).

5. Install the underhood junction block. Refer to Underhood Fuse Block Replacement in Engine Electrical.
6. Install the battery tray.
7. Install the battery. Refer to Battery Replacement in Engine Electrical.
8. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
9. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .