Was the Lighting Systems Diagnostic System Check performed?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

Use the Scan Tool in order to command the courtesy lamps on.

Do the courtesy lamps light?

Go to Step 3

Go to Step 6

1. Disconnect the door jamb switch from the door that does not light the courtesy lamps. (If the lamps are inoperative from every door, use any door jamb switch.)
2. Monitor the DOOR AJAR SWITCH input in the LAMP STATUS data list with the Scan Tool.
3. Use a fused jumper in order to ground CKT 394, (driver door) or CKT 395 (passenger door).

Does the DOOR AJAR SWITCH input toggle?

Go to Step 5

Go to Step 4

Test CKT 395 (passenger door) or CKT 394 (driver door) for an open between the body control module (BCM) and the door jamb switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was an open found and corrected?

System OK

Go to Step 9

Test CKT 650 (passenger door) or circuit 550 (driver door) between the door jamb switch and ground for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was an open found and corrected?

System OK

Go to Step 10

Test for an open or short to ground in the power feed CKT 340 from the INT LPS fuse to the BCM connector C3 terminal A12. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was a condition found and corrected?

System OK

Go to Step 7

Test for an open or short to ground in CKT 1732 from the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was a condition found and corrected?

System OK

Go to Step 8

Test for an open in CKT 156 from the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was an open found and corrected?

System OK

Go to Step 9

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

System OK

Go to Step 11

Inspect for poor connections at the harness connector of the door jamb switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

System OK

Go to Step 12

Important: Perform the setup procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration .

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

System OK

--

Replace the door jamb switch.

Did you complete the replacement?

System OK

--