GM Service Manual Online
For 1990-2009 cars only
Makes šŸ¢’ Chevrolet šŸ¢’ 2001 šŸ¢’ Malibu šŸ¢’ Body and Accessories šŸ¢’ Lighting Systems šŸ¢’ Multifunction Turn Signal Lever Replacement - On Vehicle

Removal Procedure

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       ā€¢ Air bag deployment
       ā€¢ Personal injury
       ā€¢ Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       ā€¢ Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       ā€¢ If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the supplemental inflatable restraints (SIR). Refer to Disabling the SIR System in SIR.
  2. Remove the steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle .

    3. Object Number: 441993 Size: SH
  3. Remove the mounting screw (1) from the multifunction switch (2).
  4. Remove the multifunction switch (1) from the column (2).

    5. Object Number: 442014 Size: SH
  5. Disconnect the electrical connectors (3) from the multifunction switch (1).

Installation Procedure
  1. Connect the electrical connectors to the multifunction switch (1).

    2. Object Number: 442014 Size: SH
  2. Position the multifunction switch (1) on the steering column (2) while depressing the spring loaded horn pin.

    3. Object Number: 441993 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the mounting screw (1) to the multifunction switch (2).

    4. Tighten
    Tighten the screw to 4 NĀ·m (35 lb in).

  4. Install the steering column trim cover. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  5. Enable the SIR system. Refer to Enabling the SIR System in SIR.
  6. Ensure that the multifunction switch functions properly.