Driver or Passenger Seat Recliner Handle Replacement VIN Plant Code C, M

1. Release the retainer (2) from the base of the recliner handle (1) using a small flat-bladed tool.



2. Remove the recliner handle from the seat pulling from the recliner shaft.

1. Install a new retainer clip (2) to the recliner handle (1), if required.
2. Position the recliner handle to the recliner shaft.
3. Install the retainer handle to the shaft pressing into place until the retainer clip is fully seated.

Driver or Passenger Seat Recliner Handle Replacement VIN Plant Code 6

1. Remove the recliner handle screw.
2. Remove the recliner handle from the recliner shaft.

1. Install the recliner handle to the recliner shaft.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the recliner handle screw.

Tighten
Tighten the screw to 1 N·m (9 lb in).