GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Open the rear compartment.
  2. Mark the position of the latch on the rear compartment lid.

  3. Object Number: 283996  Size: MH
  4. Remove the lock cable from the lock cylinder. Use a flat-bladed tool to spread the plastic cover (8) and pull down.
  5. Open the cable door at the top of the lock release box (2) to expose the remote release cable, if equipped.
  6. Remove the remote release cable (1) from the lock release box, if equipped.
  7. Disconnect the electrical connector from the compartment lid lock, if equipped.
  8. Remove the rear compartment lid lock bolts (7) from the rear compartment lid.
  9. Remove the latch assembly (3) from the rear compartment lid.

Installation Procedure


    Object Number: 283996  Size: MH
  1. Position the latch assembly (3) to the alignment marks on the rear compartment lid.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the rear compartment lid latch bolts (7) to the rear compartment lid.
  4. Tighten
    Tighten the bolts to 11 N·m (97 lb in).

  5. Install the remote release cable (1) to the lock release box, if equipped.
  6. Connect the electrical connector to the rear compartment lid latch, if equipped.
  7. Press the rear compartment lid latch cable (8) onto the lock cylinder until the retainer tabs are fully seated.
  8. Close the rear compartment.