For 1990-2009 cars only
Removal Procedure
- Disconnect the negative (-) battery cable.
- Disconnect the following connectors from the radio by accessing through the instrument panel compartment:
- Remove the ashtray from the track by pushing down on the retainer and pulling out.
- Remove the following components from the instrument panel:
- Remove the cross-recess screw (1) from under the back of the radio. Access the screw through the ashtray cutout in the instrument panel.
- Remove 4 screws from the front of the radio.
- Remove the radio with the mounting bracket from the vehicle.
- Remove 5 screws and 3 radio mounting brackets from the radio, if necessary.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
| • | The radio electrical connector |
| • | The antenna connector |
| 4.1. | 4 screws (1) |
| 4.2. | The center trim bezel (3) |
Installation Procedure
- Install the radio mounting brackets to the radio, if removed. Secure the brackets with the 5 screws.
- Install the radio to the instrument panel. Secure the radio with 4 screws (1).
- Install the cross-recess screw to the radio rear mounting bracket. Access through the ashtray cutout in the instrument panel.
- Install the center trim bezel (3) to the instrument panel. Secure the bezel with the 4 screws (1).
- Install the ashtray to the ashtray track.
- Connect the following connectors. Access through the instrument panel compartment:
- Connect the negative (-) battery cable.
| • | The radio electrical connector |
| • | The antenna connector |
