Step
| Action
| Value(s)
| Yes
| No
|
1
| Do the turn signal indicator lamps illuminate when the turn signals
are operating?
| --
| Go to
Step 2
| Go to
Step 6
|
2
|
- Set the headlamp switch to the PARK position.
- Set the I/P dimmer to maximum brightness.
Do the heater-A/C control illumination lamps illuminate?
| --
| Go to
Step 3
| Refer to Lighting System
|
3
|
- Set the headlamp switch to the OFF position.
- Disconnect the instrument cluster connector.
- Set the headlamp switch to the PARK position.
- Set the I/P dimmer to maximum brightness.
- Use a DMM in order to probe between the instrument cluster harness
connector terminal C5 and ground and between terminal C6 and ground.
Is the measured voltage within the specified value for both terminals?
| 9-14 Volts
| Go to
Step 4
| Go to
Step 5
|
4
|
- Inspect the warning indicator bulb and the bulb connection.
- If OK, replace the instrument cluster. Refer to
Instrument Cluster Replacement
.
- Inspect the system.
Is the symptom still present?
| --
| Go to
Step 5
| System OK
|
5
|
- Repair a poor connection or an open in CKT 8 between the
instrument cluster harness connector terminal C5 and S203 or between terminal
C6 and S203.
- Inspect the system.
Is the symptom still present?
| --
| Go to
Step 6
| System OK
|
6
|
- Inspect the system for an open in CKT 150 between the instrument
cluster harness connector terminal D3 and G205.
- If OK, replace the instrument cluster. Refer to
Instrument Cluster Replacement
.
- Inspect the system.
Is the symptom still present?
| --
| --
| System OK
|
