Step
| Action
| Value(s)
| Yes
| No
|
1
|
- Turn the ignition switch to the LOCK position.
- Remove the key from the ignition lock cylinder.
- Disconnect the seat belt/ ignition key/ lamps alarm electrical
connector.
- Measure the resistance between the seat belt/ ignition key/ lamps
alarm harness connector terminal C1 and the ground with the DMM.
Is the resistance within specified range?
| Infinite
| Go to
Step 3
| Go to
Step 2
|
2
|
- Disconnect C201.
- Measure the resistance between the seat belt/ ignition key/ lamps
alarm harness connector terminal C1 and the ground with the DMM.
Is the resistance within specified range?
| Infinite
| Go to
Step 4
| Go to
Step 5
|
3
|
- Inspect the seat belt/ ignition key/ lamps alarm electrical connector
for a short at the ground terminal:
- Replace the seat belt/ ignition key/ lamps alarm if the connector
is OK. Refer to
Multifunction Alarm Module Replacement
.
Has the repair been made?
| --
| Go to
Step
6
| --
|
4
|
- Inspect the wiring harness in the steering column for a short
to in the CKT 80 between C201 and the ignition key warning switch.
- Replace the ignition key warning switch if the wiring is OK. Refer
to
Steering Column Lock Cylinder Set - Disassemble - Off Vehicle
in Steering Wheel and
Column.
Has the repair been made?
| --
| Go to
Step
6
| --
|
5
| Repair the short to ground in CKT 80.
Has the repair been made?
| --
| Go to
Step
6
| --
|
6
|
- Ensure the ignition switch is in the LOCK position.
- Reconnect any of removed the connectors/components.
Have all repairs been made?
| --
| Go to
Audible Warnings System Check
| --
|
