GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Monte Carlo 🢒 Body and Accessories 🢒 Body Front End 🢒 Hood Hinge Replacement

Removal Procedure

    Object Number: 363782 Size: SH
  1. Remove the hood. Refer to Hood Replacement .
  2. Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .
  3. Remove the hood rear side seal. Refer to Hood Rear Outer Seal Replacement .
  4. Remove the bolts from the hood hinge at the fender.

    5. Object Number: 363781 Size: SH
  5. Center punch the spot weld.

    6. Object Number: 363778 Size: SH
  6. Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
  7. Remove the hood hinge from the fender.

Installation Procedure

    Object Number: 363781 Size: SH
  1. Install the fender hinge to the fender.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts to the hinge at the fender.

    3. Tighten
    Tighten the hood hinge to fender bolts to 25 N·m (18 lb ft).

  3. Install the hood. Refer to Hood Replacement .
  4. Install the hood assist rod. Refer to Hood Open Assist Rod Replacement .
  5. Install the hood rear side seal. Refer to Hood Rear Outer Seal Replacement .
  6. Adjust the hood as needed. Refer to Hood Adjustment .