1. Remove the seat from the vehicle. Refer to Seat Replacement .
2. Remove the adjuster from the seat. Remove the four nuts securing the adjuster to the seat.

Important: Remove the nut that secures the motor support bracket in order to gain access to the following components:

Squeeze the oblong connector at any of the following areas and disconnect the cables.

1. Connect the cables to the drives. Insert the square end of the drive cables and press in to secure the connectors.



2. Install the two dual retainer clips.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nut that secures the motor support bracket.

Tighten
Tighten the actuator motor bracket to seat adjuster nut to 10 N·m (89 lb in).

4. Install the adjuster to the seat. Install the four nuts securing the adjuster to the seat.

Tighten
Tighten the adjuster to seat cushion frame nuts to 24 N·m (18 lb ft).

5. Install the seat in the vehicle. Refer to Seat Replacement .