Removal Procedure
- Remove the front seat. Refer to
Seat Replacement
.
- Remove the six-way power seat adjuster (2). Refer
to
Front Seat Adjuster Replacement
.
- Disassemble the following:
| 3.1. | Remove the feed wires from the following motors: |
| • | Front vertical gearnut motor (9). |
| • | Rear vertical gearnut motor (10). |
| • | Horizontal adjuster motor (3). |
| 3.2. | Remove the nut securing the front of the motor support bracket
(7) to the inboard adjuster and partially withdraw it from the adjuster (1)
and gear-nut drives (3, 13). |
| 3.3. | Remove the following drive cables from the motors and complete
disassembly of support bracket (7) with motors attached: |
| • | Front vertical drive cable (8). |
| • | Rear vertical drive cable. |
| • | Horizontal drive cable (10). |
- Grind off peened over end(s) of grommet securing motor to support
and separate motor(s) as required from support.
- Assemble the following:
| 5.1. | Drill out the top end of grommet using an 8 mm (3/16-inch)
drill bit. |
| 5.2. | Install the grommet to the motor support bracket and secure motor
to grommet using a 3/16-inch rivet. |
| 5.3. | Install the drive cables to the motors. |
| 5.4. | Install the motor to inboard adjuster and secure with nut. |
| 5.5. | Install the motor feed wires to the motors. |
Installation Procedure
- Install the six-way power seat adjuster (2).
Refer to
Front Seat Adjuster Replacement
.
- Install the front seat. Refer to
Seat Replacement
.
