Removal Procedure
Important:
• | Be sure to prefit the windshield reveal molding to the windshield
then as an assembly on the body prior to actual installation. |
• | When replacing the windshield, the original windshield reveal
molding cannot be reused and must be replaced with a new molding. |
• | The new windshield reveal moldings are primed and will adhere
to the urethane adhesive. |
• | A heat lamp may be used to make the windshield reveal molding
more pliable. |
• | The windshield reveal molding cannot be replaced without removing
the windshield. |
- Remove the windshield
using a flat-bladed tool, and carefully pry the end of the windshield reveal
molding out about 75 mm (3 in).
- Grasp the windshield reveal molding by hand and slowly pull the
windshield reveal molding away from the body.
- Remove the windshield. Refer to
Windshield Replacement
.
Installation Procedure
- Start from center and
hand press the windshield reveal molding into place.
Tape can be applied to keep windshield reveal molding flush with windshield.
- Prefit the windshield reveal molding and the windshield then as
an assembly on the body prior to actual installation.
- Install the windshield. Refer to
Windshield Replacement
.