Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedures

1. Turn the ignition switch to the OFF position.
2. If equipped with the 3.5L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
3. If equipped with the 3.9L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
4. If equipped with the 5.3L engine, remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
5. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.

1

Connector, EBCM Electrical

2

Fitting, Brake Pipe (Qty: 6)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
24 N·m (18 lb ft)

Tip
Cap the brake pipe fittings to prevent brake fluid loss and contamination.

3

Bolt, EBCM Mounting

Tighten
10 N·m (89 lb in)

4

EBCM/BPMV

5

Screw, EBCM Mounting (Qty: 4)

Tighten
5 N·m (44 lb in)

6

EBCM

Refer to Control Module References for programming and setup information.

Tip