For 1990-2009 cars only
Removal Procedure
- Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the rear brake lines (1) from the proportioning valve (2). The proportioning valves (2) are located at the rear left side of the vehicle.
- If removing both of the proportioning valves mark the brake lines for correct installation.
- Plug the brake lines to avoid brake fluid loss and brake fluid contamination.
- Remove the proportioning valve (2) from the vehicle.
Installation Procedure
- Install the proportioning valve (2) to the vehicle.
- Connect the brake lines (1) to the proportioning valve (2).
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding.
Tighten
Tighten the brake line nuts to 27 N·m (20 lb ft).
