Removal Procedure
- Remove the upper air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 2.4L.
- Remove the power steering return hose (2) from the power steering pump (1).
- Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the front exhaust pipe. Refer to Intermediate Pipe Replacement (2.4L) in Engine Exhaust.
- Remove the power steering return hose (1) from the power steering gear (3).
- Remove the power steering return hose (1) from the vehicle.
Installation Procedure
- Install the power steering return hose (1) to the vehicle.
- Install the front exhaust pipe. Refer to Intermediate Pipe Replacement (2.4L) in Engine Exhaust.
- Install the power steering return hose (1) to the power steering gear (3).
- Lower the vehicle.
- Install the power steering return hose (2) to the power steering pump (1).
- Install the upper air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 2.4L.
- Bleed the power steering system. Refer to Bleeding Power Steering System.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fitting to 27 N·m (20 lb ft).
