Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Radio/Audio System Diagnostic System Check? | -- | Go to Step 2 | |
2 | Are all of the speakers inoperative? | -- | Go to Step 7 | Go to Step 3 |
3 | Adjust the radio balance and fade to the suspect speaker. Does the speaker operate properly? | -- | Go to Step 4 | |
4 |
Does the speaker emit an audible pop? | -- | Go to Step 8 | Go to Step 5 |
5 | Test the circuits of the appropriate speaker for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 6 |
6 | Inspect for poor connections at the speaker. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 9 |
7 | Test all speaker circuits for a short to B+ or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 8 |
8 | Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 10 |
9 | Replace the speaker. Refer to Speaker Replacement or Radio Rear Speaker Replacement for service procedures. Did you complete the replacement? | -- | Go to Step 11 | -- |
10 | Replace the radio and perform the set up procedure. Refer to Radio Replacement and Radio Setup . Did you complete the replacement? | -- | Go to Step 11 | -- |
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
