- Install the steering column support assembly to the steering column jacket assembly with the 4 support screws.
- Install the steering column shaft assembly (2) into the steering column support assembly (1).
- Install the adapter and bearing assembly (2) to steering column jacket assembly (1). Position the tab on the adapter and bearing assembly with the slot in steering column jacket assembly and push together.
- Install the lower bearing seat (3).
- Install the lower bearing spring (4).
- Install the new lower spring retainer (5).
- Install the steering column jacket. Refer to Steering Column Jacket - Assemble - Off Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 8 N·m (71 lb in).
When installing, compress the lower bearing spring (4) to the length of 23.5 MM +\- .5 MM between the lower bearing seat (3) and the lower spring retainer (5).
