Removal Procedure
- Remove the instrument panel. Refer to IP Carrier Replacement.
- Disconnect the wiring harness from the tie bar.
- Remove the fuse block. Refer to Fuse Block Replacement - in this
section.
- Remove the bolts (2).
Important: Steering column must be in the straight tilt position, using the tilt
lever.
- Remove the tie bar (1) from the front of the dash.
Installation Procedure
Important: The steering column must be in the straight tilt position, using the
tilt lever.
- Install the tie bar (1) to the front of the dash.
- Install the bolts (2) and the studs (3).
Tighten
Tighten the bolts and the studs to 10 N·m (89 lb in).
- Connect the wiring harness to the tie bar.
- Install the instrument panel. Refer to IP Carrier Replacement.