The electronic ignition system is of the direct ignition system (DIS) type and is controlled by the powertrain control module (PCM). The electronic ignition system is composed of the following components:
The electronic ignition system provides the following benefits:
The electronic ignition system components cannot be disassembled or repaired. A component that is correctly diagnosed as faulty must be replaced as a complete unit.
The PCM uses reference pulses from the CKP sensor in order to determine engine speed. The PCM cannot operate the ignition system (or the fuel injectors) without the engine speed signal from the CKP. The PCM controls ignition timing by controlling the ignition coils.
Each ignition coil has a built-in ignition module that controls the current flow in the primary coil winding. When the current flow is interrupted, the electrical field around the primary coil collapses and a high voltage is induced in the secondary coil. The secondary coil voltage travels from the coil output terminal, through the spark plug boot, and across the spark plug gap to the engine block. As a fail-safe function the ignition control module sends an ignition confirmation signal back to the PCM whenever the primary field collapses.
The CMP sensor input is used to detect engine misfire. The PCM also uses the CMP sensor signal as an input for modifying fuel injection timing and modifying ignition timing.
The PCM receives information on engine status from various engine sensors and then selects the most appropriate ignition timing settings from within the PCM's programming. The following are the most important inputs for determining ignition timing requirements:
The ignition timing is not adjustable. A timing indicator and timing marks are still visible at the crankshaft pulley but are not used to set or adjust ignition timing. The powertrain control module provides all ignition timing adjustments electronically.
Do not use a conventional tachometer in order to check engine speed on this ignition system. An inductive type pick-up will not provide reliable engine speed information. Use a scan tool in order to monitor engine RPM.
The ignition coil's secondary output voltage is very high - more than 40,000 volts. Avoid body contact with the ignition high voltage secondary components when the engine is running or personal injury may result.
Be careful not to damage the secondary ignition boots when servicing the ignition system. Rotate each ignition wire boot in order to loosen the boot from the spark plug before removing the wire. Never pierce a secondary ignition wire or boot for any testing purposes. Future ignition system problems are guaranteed if pinpoints or test lights are pushed through the secondary ignition wire insulation during component testing.
This vehicle should be serviced with one of the following types of iridium tipped spark plugs.
New Spark Plug Gap 1.0-1.1 mm (0.040-0.043 in)
Maximum Used Spark Plug Gap 1.2 mm (0.047 in)
Normal service is assumed to be a mixture of idling, slow-speed and high-speed driving. Occasional or intermittent highway driving is needed for good spark plug performance. The higher combustion temperatures generated during highway driving burn away carbon and oxide deposits that have built up from frequent idling or continuous stop and go driving.
Spark plugs must operate within certain temperature limits to provide the performance and service life expected. The spark plugs selected for an engine is based only on normal engine service, and may not apply for abnormal engine service conditions. For instance, a spark plug one step hotter in heat range might deliver longer service life than the spark plug recommended for almost exclusive city driving. Conversely, a spark plug one step colder than recommended will perform better for continuous high speed driving.
There are three rules to follow when selecting spark plugs for an engine in good condition:
The ignition switch is located on the right side of the steering column below the steering wheel. The electrical and mechanical portions of the switch work in conjunction with each other. For more information refer to Steering Wheel and Column.
