Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Column Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Lubricate the following parts with synthetic grease:

•	The inner race (1).

•	The lower brass surface of the turn signal cancel cam assembly (4).

2. Install the following parts onto the steering shaft assembly:

•	The inner race (1)

•	The upper bearing inner race seat (2)

•	The upper bearing spring (3)

•	The turn signal cancel cam assembly (4)

•	The shaft lock shield assembly (5)




3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR from the steering shaft assembly.
7. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .