Battery Cable Replacement Negative

Important: Whenever battery cables are being replaced, always be certain to use a replacement cable that is the same type, size and length. Some positive (+) cables have additional feed wires attached to them and some negative (-) cables have additional ground leads attached. Always be certain to route the replacement battery cable in exactly the same manner as the original cable.

1. Remove the battery from the vehicle. Refer to Battery Replacement .




Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Remove the ground bolt and the negative (-) battery cable (4) from the body.
3. Remove the ground bolt and the cable from the starter motor housing.
4. Remove the cable from the harness retainer near the starter motor and remove the cable from the vehicle.

1. Position the negative (-) battery cable (4) into the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Connect the cable to the starter motor housing. Secure with the ground bolt.

Tighten
Tighten the ground bolt to 23 N·m (17 lb ft).

3. Connect the cable to the body. Secure with the ground bolt.

Tighten
Tighten the body ground bolt to 14 N·m (124 lb in).

4. Route the cable and secure it in the harness retainer near the starter motor.
5. Install the battery into the vehicle. Refer to Battery Replacement .

Battery Cable Replacement Positive

Important: Whenever battery cables are being replaced, always be certain to use a replacement cable that is the same type, size and length. Some positive (+) cables have additional feed wires attached to them and some negative (-) cables have additional ground leads attached. Always be certain to route the replacement battery cable in exactly the same manner as the original cable.

1. Remove the battery from the vehicle. Refer to Battery Replacement .
2. Remove the fuse box cover.



3. Remove the two bolts and the positive (+) battery cable (8) from the fuse box (6).
4. Remove the retaining nut and cable from the starter solenoid.
5. Remove the retaining nut and the cable from the generator.
6. Remove the cable from the harness retainers and remove the cable from the vehicle.

1. Position the positive (+) battery cable (8) into the vehicle.
2. Install the cable to the generator. Secure with the retaining nut.

Tighten
Tighten the positive (+) battery cable-to-generator retaining nut to 8 N·m (71 lb in).

3. Install the cable to the starter solenoid. Secure the cable with the retaining nut.

Tighten
Tighten the positive (+) battery cable-to-starter solenoid retaining nut to 7 N·m (62 lb in).

4. Install the cable to the fuse box. Secure the cable with one bolt.

Tighten
Tighten the fuse box bolt to 10 N·m (89 lb in).

5. Install the fuse box cover.
6. Route the cable. Secure the cable in the harness retainers.
7. Install the battery into the vehicle. Refer to Battery Replacement .