Important: Install the muffler/tail pipe assembly hangers in their proper position.
- Connect the muffler/tail pipe assembly (8-2 door), (7-4
door) to vehicle. Secure the tail pipe with two hangers (6) (one bolt each).
Finger tighten the bolt.
Connect the muffler/tail pipe assembly, with a new gasket, to the front
pipe/TWC assembly. Secure the assembly with two bolts and two nuts. Finger
tighten the bolts.
- Connect the hanger to the muffler. Secure the hanger with one
bolt. Finger tighten the bolt.
- Connect the hanger to the pipe at the muffler. Secure the hanger
with one bolt. Finger tighten the bolt.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Align all system
components properly to prevent any noise or vibrations before tightening fasteners.
Tighten
| • | Tighten TWC-to-muffler/tail pipe assembly bolts to 50 N·m
(57 lb ft). |
| • | Tighten all hanger bolts to 13 N·m (115 lb in). |
- Lower the vehicle.
