For 1990-2009 cars only
Removal Procedure
- Unsnap the rear garnish (3) from the lower right side of the rear door.
- Pull the upper right-side reveal molding joint (1) from the rear door.
- Pull the right-side reveal molding (2) from the rear door.
Installation Procedure
- Apply a bead of urethane adhesive from the kit GM P/N 12346284 into the cavity between the body and the window.
- Install the right-side reveal molding (2) to the rear door.
- Start at the center of the right-side reveal molding (2) in order to press the right-side reveal molding (2) in place.
- Press the upper right-side upper reveal molding joint (1) to the rear door.
- Use tape, as needed, in order to retain the right-side reveal molding (2) until the urethane cures.
- Allow the adhesive to cure according to the manufacturer's instructions.
- Install the rear garnish (3) to the lower right side of the rear door.
Important: Trim the new right-side reveal molding (2), as needed, in order to fit the right-side reveal molding (2) in the cavity between the rear door and window.
