Tools Required

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the knuckle from the drive axle. Refer to Steering Knuckle Replacement .
3. Remove the wheel hub with the CH 46560-01  (1), the hub adapter CH 46560-04  (4), the forcing bolt CH 46560-05  (3), the hex nut CH 46560-06  (2).



4. Remove the inner snap ring.



5. Remove the wheel bearing with the CH 46560-01 , CH 46560-02  (1), forcing CH 46560-05 , and CH 46560-06 .
6. Remove the oil seal from the knuckle.

1. Install the new oil seal into the knuckle.
2. Push the wheel bearing into place with the CH 46560-01 , CH 46560-03  (1), CH 46560-05 , and CH 46560-06 .
3. Install the inner snap ring.



4. Push the wheel hub into place with the CH 46560-03  (1), CH 46560-04 , CH 46560-05 , and CH 46560-06 .

Important: The inner seal must be discarded and replaced with new parts.

5. Install the knuckle into the drive axle.