Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1023 00: Integral Switch MalfunctionCircuit/System Description
The vehicle theft deterrent subsystem provides the capability to lock or unlock the steering electrically. The steering column lock control module is allowed to unlock when power mode transitions to a non off power mode and an authenticated driver identification device is present. Once the column is unlocked, a crank request can be allowed.
Conditions for Running the DTC
| • | The ignition is in OFF, ACCESSORY or RUN position. |
| • | The system voltage is between 9 V and 16 V |
Conditions for Setting the DTC
The steering column lock control module detects an internal sensor malfunction resulting in lock status of invalid to be transmitted on serial data.
Action Taken When the DTC Sets
| • | DTC B1023 is stored in memory. |
| • | The driver information center displays the service column lock system warning message. |
| • | The steering column lock indicator is ON. |
Conditions for Clearing the DTC
| • | No steering column lock control module internal sensor malfunction so lock status of valid is transmitted on serial data. |
| • | The condition for setting the DTC is no longer present. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Steering Wheel and Column Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Clear all DTCs and operate the integral switch at the steering column lock within the conditions for running the DTC. The DTC should not set.
| ⇒ | If the DTC sets, replace the K60 Steering Column Lock Control Module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for steering column lock control module replacement, setup and programming |
