Removal Procedure
- Tilt the cab. Refer to Cab Tilting
in General Information.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cables. Refer to Battery Replacement
in Engine Electrical.
- Remove the condenser fan electrical connector from the condenser
fan.
- Remove the following components from the condenser:
Installation Procedure
- Install the condenser
fan to the condenser.
Secure the condenser fan with the four bolts.
- Install the condenser fan electrical connector to the condenser
fan.
- Connect the negative battery cables. Refer to Battery Replacement
in Engine Electrical.
- Lower the cab. Refer to Cab Tilting
in General Information.