A control assembly is available from the service parts warehouses. They are offered as a complete assembly. This item cannot be serviced. Service is by replacement only.

Removal Procedure

1. Remove the cluster trim. Refer to Instrument Panel (IP) Cluster Replacement (Instrument Cluster) in Interior Trim.



2. Remove the control assembly screws.
3. Remove the control assembly.
4. Disconnect the electrical connectors.

Installation Procedure

1. Connect the electrical connectors.



2. Install the control assembly.
3. Install the control assembly screws.

Tighten
Tighten the control assembly screws to 2 N·m (18 lb in).




4. Install the cluster trim. Refer to Instrument Panel (IP) Cluster Replacement (Instrument Cluster) in Interior Trim.