GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Alero 🢒 Body and Accessories 🢒 Keyless Entry 🢒 Keyless Entry System Inoperative

Step

Action

Value(s)

Yes

No

Important: A short to ground will cause an open fuse(s). Before Performing this diagnostic procedure, inspect the fuse(s) for an open.

1

Was the Remote Keyless Entry Diagnostic System test performed?

--

Go to Step 2

Go to Remote Keyless Entry System Check .

2
  1. Inspect the door lock fuse J in the LH instrument panel wiring harness junction block. Verify that the following conditions exist:
    2. • The fuse is not open.
    • The fuse has voltage at both of the test points in all of the ignition switch positions.
  2. Connect a scan tool.
  3. Turn the ignition switch to the ON position.
  4. Select DIAGNOSTICS on the scan tool.
  5. Select DIAGNOSTIC CIRCUIT CHECK.
  6. Select CLASS 2 MESSAGE MONITOR.

Are the BCM and RFA listed as ACTIVE?

--

Go to Step 3

Go to Scan Tool Cannot Communicate with RFA

3
  1. Close the doors.
  2. Attempt to lock and unlock the doors.

Do the doors lock and unlock?

--

Go to Step 7

Go to Step 6

4
  1. Resynchronize the keyless entry transmitters. Refer to Transmitter Synchronization .
  2. Attempt to lock and unlock the doors using the transmitter.

Do the doors lock and unlock?

Go to Remote Keyless Entry System Check

Go to Step 9

5
  1. Using a scan tool, select RFA DATA - KEY FOB INFORMATION.
  2. Press the LOCK and UNLOCK buttons on the keyless entry transmitters.

Does the status change?

--

Go to Step 9

Go to Step 11

6
  1. Select BCM SPECIAL FUNCTIONS on the scan tool.
  2. Command the door locks to lock and unlock.

Do the door locks operate?

--

Go to Step 7

Go to Step 10

7
  1. Select RFA SPECIAL FUNCTIONS on the scan tool.
  2. Select PROGRAM KEY FOBS.

Was the reprogramming successful?

--

Go to Step 8

Go to Step 12

8

Resynchronize the system with a known good transmitter.

Was resynchronization successful?

--

Go to Remote Keyless Entry System Check

--

9
  1. Replace the transmitter battery. Refer to Transmitter Battery Replacement .
  2. Resynchronize the transmitter.

Do the doors lock and unlock?

--

Go to Remote Keyless Entry System Check

Go to Step 5

10
  1. Replace the BCM.
  2. Reprogram the BCM with the current calibrations.

Is the reprogramming complete?

--

Go to Step 5

--

11

Replace the transmitter key fob.

Is the repair complete?

--

Go to Step 4

--

12

Replace the RFA module. Refer to Receiver Replacement .

Is the repair complete?

--

Go to Step 7

--