GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 41531  Size: SH
  1. Loosen both air duct clamps.
  2. Remove duct from air cleaner and rotate duct upwards around the MAF sensor.

  3. Object Number: 41529  Size: SH
  4. Remove the inlet snorkel by pulling upwards and inboard.

Installation Procedure


    Object Number: 41531  Size: SH
  1. Rotate the intake air duct down.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the intake air duct onto the air cleaner cover.
  4. Tighten
    Tighten both air cleaner duct clamps to 3.5 N·m (31 lb in) at the throttle body and 1.8 N·m (16 lb in) at the air cleaner.