Tools Required

J 28467-A Engine Support Fixture

1. Install the J 28467-A .
2. Install the front core support adapter.
3. Install the engine core support bar.
4. Install the engine support fixture adapter.
5. Remove the windshield washer reservoir.
6. Detach the engine compartment positive battery junction block and move aside.



7. Remove the mount to body through bolt.
8. Remove the torque axis mount from the engine mount bracket.
9. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
10. Remove the right front wheel/tire assembly.
11. Remove the splash shield from the wheel well.
12. Remove the lower center air deflector.
13. Remove the left transaxle mount to frame through bolt.
14. Remove the lower retaining bolt and nut from the engine mount bracket.
15. Disconnect the power steering line retainer from the bracket.
16. Lower the vehicle.
17. Remove the upper retaining bolt and nut from the engine mount bracket.
18. Release the drive belt tensioner.
19. Remove the belt from the power steering pump.



20. Remove the intake sight shield.



21. Remove the power steering pump. Set the pump aside.
22. Raise the engine at the support fixture.
23. Remove the engine mount bracket from the engine.
24. Remove the torque axis mount from the body.

Tools Required

J 28467-A Engine Support Fixture

1. Install the torque axis mount into the body.
2. Install the engine mount bracket to the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the engine mount bracket to engine nuts and bolts.

Tighten

•	Tighten the mount bracket to engine nuts to 40 N·m (30 lb ft).

•	Tighten the mount bracket to engine bolts. to 55 N·m (41 lb ft).

4. Lower the engine at the support fixture.



5. Install the power steering pump.

Tighten
Tighten the power steering pump to 50 N·m (37 lb ft).

6. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
7. Install the left transaxle mount to frame through bolt.
8. Install the lower center air deflector.
9. Install the splash shield to the wheel well.
10. Install the wheel/tire assembly.
11. Lower the vehicle.
12. Install the torque axis mount to the engine mount bracket.
13. Install the torque axis mount to the engine mount bracket bolt.

Tighten
Tighten the mount to engine bracket bolt to 95 N·m (70 lb ft).

14. Install the mount to body through bolt.

Tighten
Tighten the mount to body through bolt to 50 N·m (37 lb ft).




15. Remove the J 28467-A .