GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Aurora 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Fasten Safety Belt Indicator/Chime Inoperative

Fasten Safety Belt Indicator/Chime Inoperative Buick

Step

Action

Value(s)

Yes

No

1

Perform the Audible Warnings System Check before processing.

Is the system check complete?

--

Go to Step 2

Go to Audible Warnings System Check

2
  1. Turn the ignition switch to OFF.
  2. Disconnect the instrument cluster connector C1.
  3. Measure the resistance from the instrument cluster connector C1 terminal E12 and terminal F12 to ground.

Does the resistance measure less than the specified value?

10 V

Go to Step 3

Go to Step 7

3
  1. Turn the ignition switch to RUN.
  2. Measure the voltage from the instrument cluster connector C1 terminal F3 to ground.

Does the measured voltage equal the specified value for approximately one minute after you turn the ignition switch to run?

--

Go to Step 8

Go to Step 4

4

Inspect CKT 234 (YEL) for an open.

Is the circuit OK?

--

Go to Step 5

Go to Step 7

5

Inspect the mall module connector C2 for proper terminal contact.

Is the contact OK?

--

Go to Step 6

--

6

Replace the mall module.

Is the repair complete?

--

Go to Audible Warnings System Check

--

7

Repair the open.

Is the repair complete?

--

Go to Audible Warnings System Check

--

8

Replace the fasten seat belts indicator.

Is the repair complete?

--

Go to Audible Warnings System Check

--

Fasten Safety Belt Indicator/Chime Inoperative Oldsmobile

Step

Action

Value(s)

Yes

No

1

Perform the Audible Warnings System Check before processing.

Is the system check complete?

--

Go to Step 2

Go to Audible Warnings System Check

2
  1. Turn the ignition switch to OFF.
  2. Disconnect the instrument cluster connector C1.
  3. Measure the resistance from the instrument cluster connector C1 terminal E12 and terminal F12 to ground.

Does the resistance measure less than the specified value?

10 V

Go to Step 3

Go to Step 7

3
  1. Turn the ignition switch to RUN.
  2. Measure the voltage from the instrument cluster connector C1 terminal F3 to ground.

Does the measured voltage equal the specified value for approximately one minute after you turn the ignition switch to run?

--

Go to Step 8

Go to Step 4

4

Inspect CKT 234 (YEL) for an open.

Is the circuit OK?

--

Go to Step 5

Go to Step 7

5

Inspect the mall module connector C2 for proper terminal contact.

Is the contact OK?

--

Go to Step 6

--

6

Replace the mall module.

Is the repair complete?

--

Go to Audible Warnings System Check

--

7

Repair the open.

Is the repair complete?

--

Go to Audible Warnings System Check

--

8

Replace the fasten seat belts indicator.

Is the repair complete?

--

Go to Audible Warnings System Check

--