Perform the Audible Warnings System Check before processing.

Is the system check complete?

--

Go to Step 2

Go to Audible Warnings System Check

1. Turn the ignition switch to RUN.
2. Enter the body control module (mall) diagnostic mode. by completing the following procedure:

2.1.	Press the power unlock switch. Hold the power unlock switch.

2.2.	Cycle the headlights 6 times.

2.3.	Release the power unlock switch.

3. The mall module may sound a few tones upon entering diagnostic mode. The tones are the history DTC stored in the mall module. Refer to Body Control Module for a list of these DTCs.
4. After the history DTC tones, the mall goes into input/output mode.
5. Turn on the turn signals.

Does the chime sound when the turn signal is on?

--

Go to Step 4

Go to Step 3

1. Disconnect the mall module connector C2.
2. Measure the voltage from connector C2 terminal C12 (harness side) to ground.

Is the measured voltage more than the specified value when you turn on the turn signal?

5 V

Go to Step 8

Go to Step 6

Inspect CKT 817 (DK GRN/WHT) for an open.

Is the circuit OK?

--

Go to Step 5

Go to Step 7

Perform the Vehicle Speed Input Test.

Is the test complete?

--

Go to Audible Warnings System Check

--

Inspect CKT 16 (PPL) for an open.

Is the circuit OK?

--

Go to Step 10

Go to Step 7

Repair the open or poor connection.

Is the repair complete?

--

Go to Audible Warnings System Check

--

Inspect the mall module connector C2 for proper terminal contact.

Is the contact OK?

--

Go to Step 9

--

Replace the mall module.

Is the repair complete?

--

Go to Audible Warnings System Check

--

Inspect for poor connection at terminal B of the turn signal flasher.

Is the connection ok?

--

Go to Audible Warnings System Check

Go to Step 7