1. Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.
2. Disconnect the accelerator controls cable from the accelerator controls pedal.
3. Remove the clip retaining the accelerator controls pedal.
4. Remove the accelerator controls pedal.

Important: The throttle should operate freely and without binding between full closed and wide open throttle.

1. Install the accelerator controls pedal to the pivot shaft.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the accelerator controls pedal retaining clip.

Tighten
Tighten the pedal bolts and studs to 3.0 N·m (27 lb in).

3. Connect the accelerator controls cable  to the accelerator controls pedal .
4. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for a correct carpet fit under the accelerator controls pedal.
5. Install the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges, and Console.