Tools Required

J 21854-01 Pivot Pin Remover

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
2. Remove the turn signal switch housing. Refer to Turn Signal Switch Housing - Disassemble - Off Vehicle .
3. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle .
4. Remove the tilt spring only. Refer to Tilt Spring - Disassemble - Off Vehicle .
5. Remove 2 pivot pins (1) from the steering column support assembly using J 21854-01 .



6. Remove the dual triangle sensor assembly.



7. Perform the following steps:

7.1.	Remove the boot  (4).

7.2.	Remove the steering shaft seal (3).

7.3.	Remove the sensor retainer (2).

7.4.	Remove the boot seal (1).




8. Remove the 3 flat head screws.
9. Remove the cable support bracket.



10. Remove the tilt head assembly (1) from the steering column support assembly (2) with the lower steering shaft (3) still attached.



11. Remove the tilt head assembly (1) from the steering shaft assembly (2).




Important: Mark the race and upper shaft (1) and the lower steering shaft (2) to ensure proper assembly. Failure to assemble properly will cause the steering wheel to be turned 180 degrees.

12. Tilt the upper shaft assembly 90 degrees to the steering shaft assembly and disengage.