Coolant Heater Cord Replacement LX5

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Disconnect the coolant heater cord (2) from the right coolant heater (4).
3. Disconnect the coolant heater cord clip (3) from the vehicle speed sensor stud.
4. Lower the vehicle.
5. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.5L.
6. Cut the coolant heater cord straps (1) from the engine wiring harness.



7. Disconnect the coolant heater cord (2) from the left coolant heater (3).
8. Remove the coolant heater cord (2) from the retainer clips (1).
9. Remove the coolant heater cord (2) from the loom at the rear engine lift bracket.
10. Remove the coolant heater cord (2) from the vehicle.

1. Install the coolant heater cord (2) to the vehicle.
2. Connect the coolant heater cord (2) to the left coolant heater (3).
3. Route the coolant heater cord (2) through the retainer clips (1).
4. Secure the excess coolant heater cord (2) to the loom at the rear engine lift bracket.



5. Tie new coolant heater cord straps (1) to the engine wiring harness at the front of the engine.
6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
7. Connect the coolant heater cord (2) to the right coolant heater (4).
8. Connect the coolant heater cord clip (3) to the vehicle speed sensor stud.
9. Lower the vehicle.
10. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.5L.

Coolant Heater Cord Replacement L47

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



2. Disconnect the coolant heater cord (1) from the right coolant heater (3).
3. Lower the vehicle.
4. Cut the coolant heater cord strap (2) from the engine wiring harness.



5. Disconnect the coolant heater cord (1) from the left coolant heater (3).
6. Cut the coolant heater cord straps (2) from the engine wiring harness.
7. Remove the coolant heater cord (1) from the loom at the fuel rail support bracket.
8. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 4.0L.



9. Remove the coolant heater cord clips (3) from the fuel injector sight shield studs.
10. Remove the coolant heater cord (2) from the vehicle.

1. Install the coolant heater cord (2) to the vehicle.
2. Place the coolant heater cord clips (3) over the fuel injector sight shield studs.
3. Tie a new coolant heater cord strap (1) to the engine wiring harness at the front of the engine.



4. Connect the coolant heater cord (1) to the left coolant heater (3).
5. Tie new coolant heater cord straps (2) to the engine wiring harness at the rear of the engine.
6. Secure the excess coolant heater cord (1) to the loom at the fuel rail support bracket.
7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



8. Connect the coolant heater cord (1) to the right coolant heater (3).
9. Lower the vehicle.
10. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 4.0L.