Tools Required

J 25070 Heat Gun

Important: Use the tape for protection and alignment marks for alignment of the new emblem.

1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Remove the emblem/nameplate from the door surface using a small plastic flat-bladed tool, being careful not to damage paint.



5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
6. Clean the door surface using Varnish Makers and Painters (VMP) naphtha.

1. If the location of the emblem/nameplate has not been marked apply tape and use the following dimensions:

•	Dimension "A" is 70.0 mm (2.76 in) from the front edge of the hood.

•	Dimension "B" is 43.5 mm (1.71 in) from the centerline of the hood (1).




2. Warm the surface with a heat gun J 25070 152 mm (6 in) from the surface to a minimum of 21°C (70°F).

Important: Do not touch the adhesive backing of the emblem/nameplate.

3. Remove the backing from the front end of the emblem/nameplate.



4. Press the emblem/nameplate (1) to the hood surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the hood to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the emblem.